0/50 ratings

Compressors are indispensable in various fields. Using devices of this type, it becomes possible to operate various devices and devices both in the domestic and in technical terms.

Immediately after purchasing a car, you must have a tire pump. Your trunk should always have this important item. Now, at every step in the city, you can meet tire fitting, where all the wheels will be pumped to you in a matter of minutes. But you are not always in the city. It may happen that you will be on the road, lower the wheel, and you will definitely need your own pump. Or the battery may even sit down, then a combination device that combines both a compressor and a charger will come in handy. It will help you deal with this situation. But do not rush immediately to run looking for yourself the best jump starter with air compressor, first you need to figure out how to connect it.

What is the design of compressors for car tires

When choosing such a compressor for tire inflation, you need to know that they are divided into:

  • piston;
  • vibrating.

As a rule, vibration compressors have a low price, but perhaps this is their only advantage over reciprocating compressors.

In turn, reciprocating compressors can inflate the tires of almost any car and can develop a lot of pressure.

Performance of the compressor connection process

Automotive tire inflation compressors can work:

  • from the vehicle electrical system;
  • and some models run on their own, built-in batteries.

Low-powered auto tire compressors are connected to the vehicle’s on-board network through the cigarette lighter socket, and high-performance and powerful tire inflation compressors are usually connected directly to the battery terminals using clips. The most low-power and low-performance automobile compressors are compressors powered by an internal battery — usually, the charge of such a battery is enough to inflate one, and at best two tires.

In order for the device to function without failures, it is necessary to correctly connect.

You must use the available wires to connect to the polar terminals of the battery, (plus to plus, minus to minus). Work must be carried out with the battery turned off and fully charged, if the battery is old, it must first be charged.

Properly connect the terminals will help the factory marking (determining the polarity) applied to them.

As you can see from the information presented, the entire connection process is quite simple, and its implementation is within the power of a person with initial skills in the field of electrical.

How to use the right compressor for tires

When using a compressor that receives energy from a car battery, you need to periodically start the car’s engine to recharge the battery, since if the compressor is powerful, the car’s battery discharges quite quickly.

As you can see, there is nothing complicated in connecting, you just need to follow the instructions.

There are currently no comments.